The Explore ATMEL PRO Kit comes with all the things required, not just for this experiment
but for the entire series. The base board is fully open, no peripheral is directly connected
to the MCU breakout board. You may connect any peripheral to any port/pin you wish. The kit
is fully open source, you may use the schematics, the design files and all of the source
code and build something cool on your own.
ATMEL PRO is simple but powerful board which uses the MCU AT89S52 from Atmel.
With its variety of interfaces this board is suitable for different embedded systems
applications.
The ATMEL PRO evaluation board supports all operating modes of the 8051 and
251 microcontrollers and lets you become familiar with the different modes of these devices.
Board Features
DIP 40 Pin ZIF (Zero Insertion Force) Socket. For Easy Insert/Remove of IC.
8051 Development Board Support AT89S51, AT89S52, P89V51RD2, etc. 40-Pin DIP Chip.
USB Programmer can be used for both 8051 and AVR ICs.
On-Board 5 mm Power Plug-in DC Jack
On-Board 5V and 3.3V regulator circuit.
On-Board Power ON-OFF switch and power indication RED LED.
On-Board 4 Input User Switches (pulled up internally).
On-board Quartz Crystal 11.05892 MHz
Port Extensions for all PORT with Detailed Pin Labeling for Easy Identification of Pin
External Pull-Up resistors for Port 0
On-board Reset button
Canbe operated from USB
Dimensions: 120x38 mm (4.7x1.5")
The story of the Kit does not end here. The kit ships with all the additional stuff mentioned below to get you started;
kickstart your embedded development. What are you waiting for?
Peripherals Built-in
16x2 LCD
8x8 LED Dot Matrix
On Board USB Programmer
DC +5V, +3.3V GND
LDR Circuit
Buzzer Circuit
4x7Segment Matrix Display Circuit.
RTC DS1307 Circuit with battery.
EEPROM 24C02 Circuit
ADC0804 Circuit
RF Transmiter and Receiver Circuit.
IR Receiver Circuit
LM35 Temp. Sensor Circuit
DS18B20 Temp. Sensor Circuit
Potentiometer Circuit
Relay Circuit
L293D H-Bridge motor Controller Circuit.
ULN2803 Stepper Driver Circuit.
74HC595 Shift Register Circuit.
28PIN DIP Socket to support PIC or ATMEGA MCU
Bread Board for extension circuits.
Package Content
ATMEL PRO Evaluation Board.
ATMEL PRO Evaluation Board User’s Guide (this manual),
Power Adapter (12v 1a External)
Motor (DC and Stepper)
Keypad Matrix (Membrane Type)
Connectors (M2M, M2F, F2F)
USB Programming Cable
Softcopy CD( MIDE-51, PROTEUS, PICKIT2, Data sheets and Notes.).
BOARD USE REQUIREMENTS:
If you connect it with your pc it is cappable to operate all of its
builin peripheral except the motors only.
